Podman : Install2024/02/28 |
|
Install Podman that is the Container management tool. |
|
| [1] | Install Podman. |
|
root@dlp:~ # pkg install -y podman
|
| [2] | Configure required settings. |
|
# mount fdescfs root@dlp:~ # mount -t fdescfs fdesc /dev/fd
root@dlp:~ #
vi /etc/fstab # add the line # Device Mountpoint FStype Options Dump Pass# /dev/gpt/efiboot0 /boot/efi msdosfs rw 2 2 /dev/vtbd0p3 none swap sw 0 0 fdesc /dev/fd fdescfs rw 0 0root@dlp:~ # ifconfig
vtnet0: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500
options=4c07bb<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU,VLAN_HWCSUM,TSO4,TSO6,LRO,VLAN_HWTSO,LINKSTATE,TXCSUM_IPV6>
ether 52:54:00:6c:78:51
inet 10.0.0.30 netmask 0xffffff00 broadcast 10.0.0.255
inet6 fe80::5054:ff:fe6c:7851%vtnet0 prefixlen 64 scopeid 0x1
media: Ethernet autoselect (10Gbase-T <full-duplex>)
status: active
nd6 options=23<PERFORMNUD,ACCEPT_RTADV,AUTO_LINKLOCAL>
lo0: flags=1008049<UP,LOOPBACK,RUNNING,MULTICAST,LOWER_UP> metric 0 mtu 16384
options=680003<RXCSUM,TXCSUM,LINKSTATE,RXCSUM_IPV6,TXCSUM_IPV6>
inet 127.0.0.1 netmask 0xff000000
inet6 ::1 prefixlen 128
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x2
groups: lo
nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
root@dlp:~ #
root@dlp:~ # ifconfig vtnet0 -rxcsum -txcsum -rxcsum6 -txcsum6 -tso -lro root@dlp:~ # echo "ifconfig vtnet0 -rxcsum -txcsum -rxcsum6 -txcsum6 -tso -lro" >> /etc/rc.conf
cp /usr/local/etc/containers/pf.conf.sample /etc/pf.conf
root@dlp:~ #
vi /etc/pf.conf # change to your interface name v4egress_if = "vtnet0" v6egress_if = "vtnet0"
root@dlp:~ #
service pf enable pf enabled in /etc/rc.conf root@dlp:~ # service pf start Enabling pf. # if your system is not configured with ZFS, change setting below root@dlp:~ # vi /usr/local/etc/containers/storage.conf # line 17 : change to vfs driver = " vfs "
# verify podman command root@dlp:~ # podman images REPOSITORY TAG IMAGE ID CREATED SIZE |
| Sponsored Link |