Use mod_perl2015/01/17

	Enable mod_perl and makes Perl script be fast.
[1]	Configure PerlRun mode.

[root@www ~]#

yum -y install mod_perl

[root@www ~]#

vi /etc/httpd/conf.d/perl.conf

# line 17: uncomment

PerlSwitches -w

# line 26: uncomment

PerlSwitches -T

# line 32-39: uncomment like follows

Alias /perl /var/www/perl
<Directory /var/www/perl>

# directory for mod_perl environment

SetHandler perl-script

# looks all files as perl-scripts under this directory

# AddHandler perl-script .cgi

# if set specific files, use this line and make the line above comment

# PerlResponseHandler ModPerl::Registry

PerlResponseHandler ModPerl::PerlRun

# specify PerlRun mode

PerlOptions +ParseHeaders
Options +ExecCGI
</Directory>

# line 45-51: uncomment ( this is for the status of mod_perl )

<Location /perl-status>
   SetHandler perl-script
   PerlResponseHandler Apache2::Status
   Order deny,allow
   Deny from all
   Allow from

10.0.0.0/24

# IP address you permit

</Location>

[root@www ~]#

/etc/rc.d/init.d/httpd restart

Stopping httpd:

[ OK ]

Starting httpd:

[ OK ]

[2]	Create a perl script and make sure if it works normally. Furthermore, it's possible to see the status of mod_perl at "http://(hostname or IP address)/perl-status".

[3]	Configure Registry mode. This mode makes Perl script be more fast than PerlRun mode, but be careful to write scripts.

[root@www ~]#

vi /etc/httpd/conf.d/perl.conf

Alias /perl /var/www/perl
<Directory /var/www/perl>
   SetHandler perl-script
#   AddHandler perl-script .cgi
   PerlResponseHandler ModPerl::Registry

# uncomment

PerlResponseHandler ModPerl::PerlRun

# comment out

PerlOptions +ParseHeaders
Options +ExecCGI
</Directory>

[root@www ~]#

/etc/rc.d/init.d/httpd restart

Stopping httpd:

[ OK ]

Starting httpd:

[ OK ]

Matched Content