Initial Settings : Network Settings2020/04/24 |
|
Change to static IP addres if you use Ubuntu as a server.
|
|
| [1] | The interface name [enp1s0] is different on each environment, replace it to your own one. |
|
# rename to disable default setting root@dlp:~# mv /etc/netplan/00-installer-config.yaml /etc/netplan/00-installer-config.yaml.org
root@dlp:~#
vi /etc/netplan/01-netcfg.yaml # create new
network:
ethernets:
# interface name
enp1s0:
dhcp4: no
# IP address/subnet mask
addresses: [10.0.0.30/24]
# default gateway
gateway4: 10.0.0.1
nameservers:
# name server to bind
addresses: [10.0.0.10]
dhcp6: no
version: 2
# apply settings root@dlp:~# netplan apply
ip addr
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: enp1s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP group default qlen 1000
link/ether 52:54:00:ac:8f:06 brd ff:ff:ff:ff:ff:ff
inet 10.0.0.30/24 brd 10.0.0.255 scope global enp1s0
valid_lft forever preferred_lft forever
inet6 fe80::5054:ff:feac:8f06/64 scope link
valid_lft forever preferred_lft forever
|
| [2] | If you don't need IPv6, it's possible to disable it like follows. |
|
root@dlp:~# echo "net.ipv6.conf.all.disable_ipv6 = 1" >> /etc/sysctl.conf
root@dlp:~#
root@dlp:~# sysctl -p net.ipv6.conf.all.disable_ipv6 = 1 ip addr
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
2: enp1s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP group default qlen 1000
link/ether 52:54:00:ac:8f:06 brd ff:ff:ff:ff:ff:ff
inet 10.0.0.30/24 brd 10.0.0.255 scope global enp1s0
valid_lft forever preferred_lft forever
|
| Sponsored Link |