iSCSI : Configure iSCSI Initiator (Server OS)2017/01/20 |
Configure iSCSI Initiator (Windows Server OS).
This example is based on the environment below.
FD3S.srv.world [10.0.0.100] - iSCSI Target RX-7.srv.world [10.0.0.101] - iSCSI initiator
|
|
[1] | Open [Control Panel] - [iSCSI Initiator]. |
[2] | Click [Yes] button to proceed. |
[3] | Input Target's Hostname or IP address on [Target] field and click [Quick Connect] button. |
[4] | iSCSI Target has been detected like follows, click [Done] button. |
[5] | Click [Connect] button. |
[6] | Click [Advanced] button. |
[7] | Check a box [Enable CHAP log on] and specify username and password on the fileds. They are the just one you set on iSCSI Target's configuration. |
[8] | Click [OK] button. |
[9] | If it's no ploblem, the status turns to [Connected] like follows. It's OK to configure iSCSI initiator settings. |
[10] | On the [Disk Management] tool, the iSCSI Disk has been attached like follows. |
[11] | After changing online and initializing iSCSI disk, it's possible to use it like follows. |
Sponsored Link |