Initial Settings : Services2019/05/06 |
| [1] | It's possible to display services' status like follows. |
|
# the list of services which are active [root@dlp ~]# systemctl -t service UNIT LOAD ACTIVE SUB DESCRIPTION abrt-journal-core.service loaded active running Creates ABRT problems fro abrt-oops.service loaded active running ABRT kernel log watcher abrt-xorg.service loaded active running ABRT Xorg log watcher abrtd.service loaded active running ABRT Automated Bug Report atd.service loaded active running Deferred execution schedu ..... ..... user-runtime-dir@0.service loaded active exited /run/user/0 mount wrapper user@0.service loaded active running User Manager for UID 0 LOAD = Reflects whether the unit definition was properly loaded. ACTIVE = The high-level unit activation state, i.e. generalization of SUB. SUB = The low-level unit activation state, values depend on unit type. 48 loaded units listed. Pass --all to see loaded but inactive units, too. To show all installed unit files use 'systemctl list-unit-files'. # the list of all services [root@dlp ~]# systemctl list-unit-files -t service UNIT FILE STATE abrt-ccpp.service disabled abrt-journal-core.service enabled abrt-oops.service enabled abrt-pstoreoops.service disabled abrt-vmcore.service enabled abrt-xorg.service enabled abrtd.service enabled arp-ethers.service disabled atd.service enabled auditd.service enabled ..... ..... |
| [2] | Stop and turn OFF auto-start setting for a service if you don'd need it. (it's smartd as an example below) |
|
[root@dlp ~]# systemctl stop smartd [root@dlp ~]# systemctl disable smartd |
| Sponsored Link |